Jamara, 081805, Lipo Safe Audio/LED 2-4 cels 1pc.
The Lipo Save Audio LED monitors individual cells at 2-4 Lipoakkupacks cells during discharge. It warns when reaching the cut-off voltage, and protects the cells of a possible deep discharge.
specifications:
- Number of cells: 2S - 4S LiPo
- Warning Voltage 3.0 " 3.7 V LiPo batteries
- Alarm Delay Start: 0 sec, 0.5 sec, 1 sec, 1.5 sec, 2 sec, 2.5 sec, 3 sec, 3.5 sec .......
- Alarm Time: 1 sec, 2 sec, 3 sec, 4 sec, 5 sec, 10 sec, 15 sec, 20 sec ........
- Tolerance: -10 mV / 10 mV
- Pitch: 2.54mm
- Dimensions: 33 x 33 x 10 mm
- Weight 10 g
- Warning LED: 11.000 MCD 2 V, 20 mA
- Warning tone: 95 dB, 12 V, 25 mA
programming:
Button 1 Set
2 Battery aansluitenl
3 Alarm LED
4 Alarm
5 Power LED
For e.g. a flight is set LiPo Save. Here the warning for low voltage can, warning time and the delay time can be programmed in easy steps.
1. Connect the LiPo Save the balancerkabel your lipo.
2. The alarm emits a short beep and the alarm LED lights up briefly during initialization. If every cell of your LiPo battery voltage, the LED gegeeft to this.
- Battery 2 cells = 2 LED
- Battery cells 3 = 3 LEDs
- Battery 4 cells = 4 LED
Then, the weakest cell is shown.
3. If the voltage LED lights, press the SET button for a few seconds, then the LED starts flashing. Now the selected lowest- voltage can be set. Briefly press the SET button and the little lights come on, indicating the selected alarm voltage. (Default setting: 3.5V) The set voltage in addition to the voltage LEDs.
4. Press the Set button for more than 3 seconds and you'll be in position to set the delay time. This is shown by the LED flashing. You can now by briefly pressing the set button to set the alarm time.
The voltage LEDs indicate the following values:
0 sec. = 3.0V
0.5 sec. = 3.1 V
1 sec. = 3.2 V
1.5 sec. = 3.3V
2 sec. = 3.4V
2.5 sec. = 3.5V
3 sec. = 3.6 V
3.5 sec. = 3.7V
(Factory setting is 0.5 sec.)
5. Press the set button more than 3 seconds. The alarm LED Lights up. By briefly pressing the set button is pressed the time suggests the alarm.
The voltage LEDs indicate the following values:
1 sec. = 3.0V
2 sec. = 3.1 V
3 sec. = 3.2 V
4 sec. = 3.3V
5 sec. = 3.4V
10 sec. = 3.5V
15 sec. = 3.6 V
20 sec. = 3.7V
(Factory default is 10 seconds.)
6. To confirm the programming, simply press the set button for more than 3 seconds. The values are stored in memory even without power continues this setting in memory. now the weakest cell is again displayed.
The Lipo Save alarm can be disabled by pressing the set button. The LiPo Safe is verpoolzeker.